Before installing Lumiman smart light strip, please make sure the cable cords are connecting at the right side.
Then you can follow the steps below to finish the installation:
1. Add the device and select the Device Type.
2. Power on the device and press the remote "On" Button or controller button for 5 seconds till the strip light is blinking rapidly.
3. Please double check your phone should connect to a 2.4 GHz Wi-Fi network, not a 5 GHz Wi-Fi, and make sure the password is inputted correctly.
4. Please make sure the WiFi signal is not too weak at the installed location and there is no metal shield, such as a metal lampshade, that can block the WiFi signal. During the setup process, your phone will wirelessly send information to the smart device and the smart device will try to connect to your WiFi router, please make sure your phone, the smart device, and your WiFi router are close to each other.
Here is a video to show you the step-by-step installation process:
Leave a comment
All comments are moderated before being published.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.